Skip to content

Resources

Pixel pitch, resolution, brightness, refresh rate and processing: which numbers decide whether a wall suits your production.

Updated:

An LED wall is described by a handful of numbers. These are the ones that change what you should rent.

Pixel pitch and viewing distance

Pitch is the distance between pixel centres in millimetres. A working rule: the closest comfortable viewing distance in metres is roughly the pitch in millimetres. A 2.6 mm wall reads cleanly from about 2.6 m; a 3.9 mm wall from about 4 m. Finer pitch than the audience can resolve adds cost, weight and processing without adding visible detail. Cameras are the exception: a camera close to the wall sees moiré that a finer pitch reduces.

Resolution is a product of size

LED resolution is not chosen, it is the result of physical size divided by pitch. A common 500 × 500 mm panel at 2.6 mm is 192 × 192 pixels, so a wall 12 panels wide and 6 high is 2304 × 1152. Tell your content team the pixel canvas early; content built for 1920 × 1080 will be scaled or cropped on a wall that is not 16:9.

Brightness

Measured in nits (cd/m²). Indoor products typically reach around 1,000 to 1,500 nits and are run well below that. Outdoor products are several times brighter, because they compete with daylight. An outdoor panel can be dimmed for indoor use; an indoor panel cannot be made daylight-readable.

Refresh rate and cameras

If the wall will be filmed, refresh rate and the processor's handling of low brightness matter more than peak brightness. A high refresh rate (3,840 Hz is a common figure) and a processor that can be genlocked reduce scan lines and flicker on camera. Say in your rider whether the wall appears in shot.

Processing and signal

Each processor output drives a limited number of pixels, so large walls need more ports or more processors, and the data cabling plan follows from that. Also state how many sources must appear on the wall at once: windowing and layering are a processor or switcher capability, not a property of the panels.

Weight, power and support

  • Ask for weight per square metre and total, including frames, bumpers and cabling.
  • Maximum power is the figure for electrical planning; average power is lower and depends on content.
  • Decide between flown and ground-supported early. Flown walls need certified rigging points; ground support needs depth behind the wall and ballast.
  • Outdoor use needs a suitable ingress protection rating, front and rear.

What to send for a quote

Width and height in metres, indoor or outdoor, closest viewer distance, whether it is on camera, flown or ground-supported, the sources you need on screen, and the dates including build days.

← All resources